User Forum of Software BASEMENT
| BASEMENT Basic Simulation Environment for computation of environmental flow and natural hazard simulation Laboratory of Hydraulics, Hydrology and Glaciology (VAW) ETH Zurich |  |
You are not logged in.
- Topics: Active | Unanswered
#1 2016-07-08 19:55:14
- sajjad
- User
- Registered: 2014-10-01
- Posts: 102
defing a closed conduit via bmg file
Hi,
I was trying to enter a circular pipe section through bmg file in basechain. Apparently, bmg file is not allowing that. Under the present condition, can one do that or does one have to wait for a new version? perhaps there is a way out, if so kindly share.
Regards
Offline