User Forum of Software BASEMENT
| BASEMENTBasic Simulation Environment for computation of environmental flow and natural hazard simulationLaboratory of Hydraulics, Hydrology and Glaciology (VAW)ETH Zurich |  |
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2025-12-24 15:04:13
- Giampietro
- User
- Registered: 2021-06-25
- Posts: 13
Mesh costrains
Hi everyone,
I would like to ask whether, during mesh generation from a DTM, it is possible to introduce points or lines with known elevations that override the original DTM values locally.
Thank you very much for your time and support.
Kind regards,
Giampietro Martini
Last edited by Giampietro (2025-12-24 15:06:51)
Offline
#2 Yesterday 12:12:54
- Matthias Bürgler
- Developer
- From: Zürich
- Registered: 2019-04-04
- Posts: 188
Re: Mesh costrains
Hi Giampietro,
The elevation interpolation tool of BASEmesh allows to use multiple elevation sources, i.e. combination of DTM and elevation meshes. You could create a local elevation mesh in the regions where you want to overwrite the DTM elevation with other elevation information. Using lines and points directly is not possible at the moment.
Best regards,
Matthias
Offline
Pages: 1