User Forum of Software BASEMENT
| BASEMENTBasic Simulation Environment for computation of environmental flow and natural hazard simulationLaboratory of Hydraulics, Hydrology and Glaciology (VAW)ETH Zurich |  |
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2021-10-18 17:09:23
- Alyssa
- User
- From: Aix-en-Provence, France
- Registered: 2019-10-28
- Posts: 41
grain size friction warning
Hi
The grain size friction can be chosen "yes" or "no". However, when adding strickler factor and roughness factor, I get the following warnings:
Warning for tag 'strickler_factor': The value for tag 'strickler_factor' will not be used as tag 'grain_size_friction' != 'on'
Warning for tag 'roughness_factor': The value for tag 'roughness_factor' will not be used as tag 'grain_size_friction' != 'on'
There is no option "on". Does it mean it is not working, or it IS working but the warning is a mistake?
Thanks
Alyssa
Offline
#2 2021-10-25 09:18:27
- Matteo Facchini
- Developer
- From: Trento
- Registered: 2014-09-05
- Posts: 281
Re: grain size friction warning
Hi Alyssa,
I guess there's a typo in the warning. Just assume that 'yes'='on' and 'no'='off'.
Refer to the input block structure if you might have any further doubt
Cheers,
Matteo
Offline
#3 2021-10-25 10:09:23
- Alyssa
- User
- From: Aix-en-Provence, France
- Registered: 2019-10-28
- Posts: 41
Re: grain size friction warning
Hi Matteo
Thanks, but the warning stays no matter the input. So when I turn it on, there is still the warning. However, I think despite the warning, it works. I guess I can just ignore the warning, just wanted to make sure and let people of Basement know.
cheers
Alyssa
Offline
Pages: 1