User Forum of Software BASEMENT

Marulke

User

Registered: 2015-11-14

Posts: 24

No erosion when using suspended transport only

Hi,
I am using BASEPLANE 2.8 for modeling sediment deposition  resulting from a river entering a reservoir.

Since most of the material is transported in suspension I started by using the suspended transport model. I did not activate bed load transport.

In general the model results shows reasonable patterns of sediment deposition.  However, there are some areas with high velocity & shear stress. In those locations there should have been scouring and considerable lowering of the river bed.

My problem is that the river bed only goes up (deposition) or remains unchanged. There is no lowering any where in the model.

Question: Is it necessary to turn on bed load transport for scouring to happen in the model?

Kind regards
Marulke

Matteo Facchini

Developer

From: Trento

Registered: 2014-09-05

Posts: 284

Re: No erosion when using suspended transport only

Hi Marulke,

did you give it a try? I think that it should be enough to define a soil with a layer to allow for erosion to happen.

Cheers,
Matteo

Marulke

User

Registered: 2015-11-14

Posts: 24

Re: No erosion when using suspended transport only

Hi,
it was my mistake. I had not defined a soil layer. When I activated a soil layer, there was also scouring,

Thanks,
Marulke