User Forum of Software BASEMENT
| BASEMENTBasic Simulation Environment for computation of environmental flow and natural hazard simulationLaboratory of Hydraulics, Hydrology and Glaciology (VAW)ETH Zurich |  |
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2020-04-02 14:12:18
- chri_and
- User
- Registered: 2017-07-27
- Posts: 34
output transport capacity
Hello
I'd to get an output from a 2D simulation with the bedload transport capacity (Geschiebetransportkapazität) and total bed load (Geschiebefrachten) . How can I do this? Can it be done over time? Can an output raster be generated?
Many Thanks
Cheers
Offline
#2 2020-05-20 10:38:32
- Matthias Bürgler
- Developer
- From: Zürich
- Registered: 2019-04-04
- Posts: 150
Re: output transport capacity
Hi
The transport capacity is not an available output for 2D simulations, as far as I know. You can generate outputs of the transported sediment (bedload_vec) on nodes or elements, though. Also with "sediment_sum" you can track the total sediment that has eroded or deposited in a cell.
Best regards
Matthias
Offline
Pages: 1