User Forum of Software BASEMENT
| BASEMENTBasic Simulation Environment for computation of environmental flow and natural hazard simulationLaboratory of Hydraulics, Hydrology and Glaciology (VAW)ETH Zurich |  |
You are not logged in.
- Topics: Active | Unanswered
#1 2015-07-23 10:44:39
- sajjad
- User
- Registered: 2014-10-01
- Posts: 102
at Hydrograph boundary flow does not enter the domain in Base. v.2.5.1
Hi,
I want to report that at a 'hydrograph' inlet bc flow is not entering the domain when the flow is low and it start entering when the flow is large. There was a warning message that the flow does not wet the cells. With exactly the same settings, the flow passed normally in v. 2.3. What should be varied to make flow enter the domain in v.2.5.1 ?
Regards
Offline
#2 2015-08-04 11:25:40
- Matteo Facchini
- Developer
- From: Trento
- Registered: 2014-09-05
- Posts: 284
Re: at Hydrograph boundary flow does not enter the domain in Base. v.2.5.1
Hi sajjad,
what is the minimum water depth that you have set?
Bests,
Matteo
Offline
#3 2015-08-05 07:04:48
- sajjad
- User
- Registered: 2014-10-01
- Posts: 102
Re: at Hydrograph boundary flow does not enter the domain in Base. v.2.5.1
Hello,
it is 5 cm.
Regards
Offline
#4 2015-08-05 14:06:11
- Matteo Facchini
- Developer
- From: Trento
- Registered: 2014-09-05
- Posts: 284
Re: at Hydrograph boundary flow does not enter the domain in Base. v.2.5.1
Is the inflow discharge enough to 'produce' 5 cm water inside your domain? Because with 5 cm minimum water depth every cell that has less than 5 cm water inside is considered wet.
Offline