User Forum of Software BASEMENT

LydiaSeitz

User

Registered: 2014-09-08

Posts: 18

Problems with morphology

Hello everybody,

I set up the morphology part of my model and the following error message appears:

"A fatal error occurred:
There is a problem with cross section names X1.0 X100.0 in file: BASEchain\BCTopoRestartBMG.cpp on line 158
Version 2.4R1692, compiled at Sep 10 2014, 11:03:11

We are sorry, but BASEMENT must be terminated now."

X1.0 and X100.0 are the upper and lower boundary conditions.
I did not define any initial condition for the morphology part since there is only an option for "restart" which I don´t have for the first run.
The hydraulic part was running without any problem.

Do you know this problem?

Best wishes
Lydia

LydiaSeitz

User

Registered: 2014-09-08

Posts: 18

Re: Problems with morphology

I found the problem! I accidentally copied the cross sections in the GEOMETRY Block from upstream to downstream :s

Now I changed it and it´s working again