User Forum of Software BASEMENT
| BASEMENTBasic Simulation Environment for computation of environmental flow and natural hazard simulationLaboratory of Hydraulics, Hydrology and Glaciology (VAW)ETH Zurich |  |
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2016-08-19 11:30:41
- Adnan
- User
- From: Pakistan
- Registered: 2015-03-31
- Posts: 51
weir as downstream bc
hi members
in my 1- D model i have used "weir" as my downstream boundary condition but after that at my last x-section my special output are wse = bed level and discharge is zero .
why is that ?
its only at the last x-section in the domain .
regards
Offline
#2 2016-08-24 11:05:19
- Adnan
- User
- From: Pakistan
- Registered: 2015-03-31
- Posts: 51
Re: weir as downstream bc
actually i was giving the absolute height of weir instead of reference height .
figured out this problem .thanx
Last edited by Adnan (2017-02-01 07:20:03)
Offline
#3 2017-01-31 18:44:26
- Matteo Facchini
- Developer
- From: Trento
- Registered: 2014-09-05
- Posts: 286
Re: weir as downstream bc
Hi Adnan,
can you provide your solution to the community?
Thanks!
Matteo
Offline
Pages: 1