User Forum of Software BASEMENT

BASEMENT
Basic Simulation Environment for computation of environmental flow and natural hazard simulation
Laboratory of Hydraulics, Hydrology and Glaciology (VAW)
ETH Zurich
Basement_Logo

You are not logged in.

#1 Today 16:53:09

Matteo Facchini
Developer
From: Trento
Registered: 2014-09-05
Posts: 303

source for bedload

Hi
I am considering to use the SOURCE as an input for hydraulics and morphology.
For hydraulics it is pretty straightforward: one sets the SOURCE with name, region_name, type and data or data_file.
I was trying and set both the hydro and morpho boundary conditions with sources, but I got kind of stuck and I can't wrap my head around it, even after looking at the docs: why is a sink required? And there is no way to set the source with some sort of transport capacity, right?

Offline

Board footer

Powered by FluxBB