User Forum of Software BASEMENT

Stefano

User

Registered: 2024-05-08

Posts: 16

Batch mode

Hi everyone,

I need to run an hydraulic simulation in batch mode under Windows (Office 365), turning off "safe mode", running BASEMD with BASEMENT 4.0.2.
I open Command prompt and digitize exactly the command lines of section 5.3 of manual (updating directories and correcting nthreats with nthreads):

C:\"Program Files\BASEMENT 4.0.2"\bin\BMv4_setup.exe `
F:\Project_1\model.json `
-o F:\Project_1\setup.h5
C:\"Program Files\BASEMENT 4.0.2"\bin\BMv4_simulation.exe `
F:\Project_1\simulation.json `
F:\Project_1\setup.h5 `
--output F:\Project_1\results.h5 --backend omp --nthreats 4
C:\"Program Files\BASEMENT 4.0.2"\bin\BMv4_results.exe `
F:\Project_1\results.json `
F:\Project_1\results.h5 `
--output F:\Project_1\results.xdmf

First question: how can I deactivate "safe mode"? --debug or -d don't work.
Second question: after the thrid step what have I to do? running with GUI?

User manual give another choice: running batch mode without GUI. I understand I've to create a text file with the subsequent command lines:

C:\"Program Files\BASEMENT 4.0.2"\bin\BMv4_setup.exe `
F:\Project_1\model.json `
-o F:\Project_1\setup.h5
C:\"Program Files\BASEMENT 4.0.2"\bin\BMv4_simulation.exe `
F:\Project_1\simulation.json `
F:\Project_1\setup.h5 `
--output F:\Project_1\results.h5 --backend omp --nthreats 4
C:\"Program Files\BASEMENT 4.0.2"\bin\BMv4_results.exe `
F:\Project_1\results.json `
F:\Project_1\results.h5 `
--output F:\Project_1\results.xdmf
C:\"Program Files\BASEMENT 4.0.2"\bin\BMv4_setup.exe `
F:\Project_2\model.json `
-o F:\Project_2\setup.h5
C:\"Program Files\BASEMENT 4.0.2"\bin\BMv4_simulation.exe `
F:\Project_2\simulation.json `
F:\Project_2\setup.h5 `
--output F:\Project_2\results.h5 --backend omp --nthreats 4
C:\"Program Files\BASEMENT 4.0.2"\bin\BMv4_results.exe `
F:\Project_2\results.json `
F:\Project_2\results.h5 `
--output F:\Project_2\results.xdmf

Then the text file has to rename to ".bat" extension and by double cliking simulation should start.

Third question: have I to create another directory (F:\Project_2 in the example)? and, again, what is correct syntax to deactivate "safe mode"?

Thanks since now to anyone could help to understana and solve this aenigma.

Stefano

Stefano

User

Registered: 2024-05-08

Posts: 16

Re: Batch mode

Ok, compiled exactly as in manual batch file runs; but flags d or debug are "unknow option".