User Forum of Software BASEMENT

nicolagroff

User

Registered: 2017-08-07

Posts: 13

Fixed Bed mesh

Hi!

I'm trying to set the fixed bed elevation via a mesh.
The fixed bed mesh has the same topology as the original computational mesh; the only difference is the DTM.
When I write the model.json, I get the following error:

-> out of range (4294967295>=2), in file: Z:\src\setup\Substance.cpp on line 188, version v4.1.0
-> ... unfortunately BASEMENT is killed!

If I remove the FIXED_BED block or if I assign the fixed bed via regions, I do not receive any error messages.

I hope you can download the files from this link

https://drive.google.com/drive/folders/ … drive_link

Thanks

Nicola