User Forum of Software BASEMENT
| BASEMENTBasic Simulation Environment for computation of environmental flow and natural hazard simulationLaboratory of Hydraulics, Hydrology and Glaciology (VAW)ETH Zurich |  |
You are not logged in.
- Topics: Active | Unanswered
#1 2019-05-17 14:11:27
- sscherer
- User
- From: Zürich
- Registered: 2019-05-17
- Posts: 1
Error Message: morphodynamic simulation
Hello
I wanted to run a morphodynamic simulation starting from the previous conducted hydrodynamic steady state simulation, but it does not work. The console shows the following error output when running the simulation (I could write the Setup File):
-> not all needed results are found for t=0s, in file: /home/BMv3/src/dataio/ResultReader.cpp on line 75, version v3.0pre
-> ... unfortunately BASEMENT is killed!
What do I have to change? Or what am I missing?
Thank you very much for your help.
Regards, Samira
Offline
#2 2019-05-20 08:45:55
- Matthias Bürgler
- Developer
- From: Zürich
- Registered: 2019-04-04
- Posts: 150
Re: Error Message: morphodynamic simulation
Hi Samira
Could you specify the time settings of your hydro- and morphodynamic simulations? Which time steps did you write during the previous hydrodynamic simulation and from which time do you want to start? Maybe you could provide you JSON command files.
Best regards
Matthias
Offline