User Forum of Software BASEMENT
| BASEMENTBasic Simulation Environment for computation of environmental flow and natural hazard simulationLaboratory of Hydraulics, Hydrology and Glaciology (VAW)ETH Zurich |  |
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2016-04-21 07:51:54
- Adnan
- User
- From: Pakistan
- Registered: 2015-03-31
- Posts: 51
Precision value
Hello
i want to know in the hydraulic block >> Parameter >>> Section-computation
with the iteration method what value of Precision you advised to use .
by default it is 0.0001 and i am getting error runing the basement and it keep saying
1 use initial wet condition ( which i am already using )
2- check the tags in Section computation ....
regards
Offline
Pages: 1