dam break analysis

medoas · 2015-06-07 06:48:51

I am trying to use BASEMENT to built a scenario of dam break using 2D .
then to define inundated areas downstream.
the following data are available .
1-Dem file covering downstream areas .
2-Max water level when dam breaks .
3-Reservoir surface area .
4-Reservoir water volume .
5-Min water level after dam break .
6-Area properties down stream .

any advice where \ and how to start .

Last edited by medoas (2015-06-07 07:24:34)

sajjad · 2015-06-07 08:40:19

Dear Medoas

You need two models:breach model and flood propagation model. As far as I know Basement do not have a breach model so either use a third part breach model ( DamBreak by USGS or a statistical model that is available as basement auxiliary utilities) or make some simplifying assumption about the breach geometry and obtain outflow hydrograph yourself. Then perform normal 2d flood propagation computation in basement applying the outflow hydrograph as 'hydrograph' boundary condition. Regards

medoas · 2015-06-09 10:19:16

dear sajjad
we get results (1d )using simplified dam break program 91 and we need to get results 2d , do you have any suggestions ?
Regards

sajjad · 2015-06-09 12:28:26

You have the DEM of the area likely to be inundated by the dam break, so no need to spend lot of time in mesh building. Get the outflow hydrograph from the program 91 and apply it to Dem (after convertng it to .2dm format) and let the baseplane do the number crunching. Regards

medoas · 2015-06-10 07:16:27

Dear Sajjad,
Thank you very much for your quick response.
Since I am new in using BASEMENT, May I kindly request your advice of how to convert my hydraulic output file into .2dm format. (i.e. which procedure do i use for that purpose).
Awaiting your reply
best regards

sajjad · 2015-06-10 11:46:21

Dear sir,

u can do that in surface water modeling sms software very easily. Regards

medoas · 2015-06-11 09:50:17

Dear sir.
how can i connect between basement output and (sms or qgis) programs ,to draw the results
best regards

sajjad · 2015-06-11 11:08:09

in basement output you specificy 'format' as 'sms'. the output files are wriiten in the format fit for visualisation with sms. Afterwards you open those files in sms for visualising. Since I am not using sms for basement visualisation, I do not have first hand experience. Consult sms documentation for visiualising output. Regards

User Forum of Software BASEMENT

#1 2015-06-07 06:48:51

dam break analysis

#2 2015-06-07 08:40:19

Re: dam break analysis

#3 2015-06-09 10:19:16

Re: dam break analysis

#4 2015-06-09 12:28:26

Re: dam break analysis

#5 2015-06-10 07:16:27

Re: dam break analysis

#6 2015-06-10 11:46:21

Re: dam break analysis

#7 2015-06-11 09:50:17

Re: dam break analysis

#8 2015-06-11 11:08:09

Re: dam break analysis

Board footer